Electrolux Washing Machine Problems: 7 Common Issues (Must Read)

Electrolux washing machines are well known for their dependability, ease of use, and ability to rapidly and silently complete loads of laundry.

However, Electrolux washers, like other machines, are susceptible to breakdowns, leaving you with a pile of dirty clothing and a dissatisfied feeling.

This article will examine 7 Common issues with Electrolux washing machines as well as potential fixes.

Toaster
Toaster

Please stick with us until the end to learn all about them.

Electrolux Washer Won’t Spin 

If your Electrolux washer is not spinning, or Electrolux washing machine clothes are wet after the cycle the problem may lie with the lid switch assembly or faulty motor. 

This switch is responsible for keeping the washer halted whenever the lid is open. If the assembly has malfunctioned, the washer will not spin.

Another problem can be the motor coupling, which connects the motor with the device’s transmission.

The motor coupling can fail if the water is overloaded or generally suffers from wear and tear over time.

Possible Solution(s):

  • Check the motor by putting your hand inside and feeling around, you can check the motor. The motor is definitely damaged if it seems flimsy or unsteady. In that situation, you ought to get in touch with a seasoned appliance repairman.
  • Check the lid switch assembly with a multimeter for continuity. If there isn’t any, replace the assembly.
  • It’s possible that the drain pump is clogged. You can inspect the drain pump by removing the bottom panel and checking the pump for any blockages

Electrolux Washer Is Making Excessive Noise

If your Electrolux washing machine is making excessive noise, the problem may be with the bearings or loose objects moving around in the washing machine. 

There are two bearings in the washing machine, one in the middle of the outer tub and the other inside the rear drum.

If any of these bearings fail, the washer will make excessive noise or leak from the bottom.

It could also be because you put the washer near another appliance which causes it to rattle every time it runs.

You may have placed the device on an uneven surface.

Possible solution(s):

  • Check for any buttons or coins that might be tumbling around in the washing machine
  • Place the washing machine on an even surface, using a spirit level to check its balanced.
  • Replacing the bearing requires complete machine disassembly, which is best done by a professional

Finally, if the washer is still making weird noises, call a technician to come out and determine the source of the noise and take the necessary steps, which in most cases will be a component replacement.


Electrolux Washer Won’t Agitate

If your Electrolux washing machine won’t agitate, the problem lies with the agitator repair kit more often than not.

This kit has all the components that allow the washer to stir, and once it malfunctions, you’ll run into issues.

Another reason can be a loose or damaged drive belt that isn’t functioning correctly due to wear and tear.

In that case, you should call a professional appliance repair person to take a look

Possible Solution(s):

  • Replace the agitator repair kit
  • Replace the drive belt

 

Electrolux Washer Isn’t Draining

If your Electrolux washing machine isn’t draining water, the drain pump may be clogged.

This pump is responsible for pushing out water from the hose, but often debris gets stuck inside the pipe, causing the drain not to function as intended.

The hose can also get blocked if a small piece of clothing like a sock gets stuck inside the pump.

Possible Solution(s):

  • Clean the drain pump. If cleaning doesn’t solve the problem, replace it
  • Remove obstruction from the drain hose.

If these solutions have worked, then it’s best to call an appliance repair person to take a look.

Electrolux Washer Won’t Start

If your Electrolux washing machine has power but doesn’t start, try pressing a few buttons on the main display to check if the control board is working.

Often a problem with the main control board causes the machine not to start, even when it has power.

Another reason can be a fault with the washing machine timer, as any malfunction can cause the entire machine to shut down.

Possible Solution(s):

  • Replace the main control board
  • Replace the faulty timer

If your Electrolux washing machine does not have power, then check for a damaged power cord connecting to the outlet.

Test the power socket by using a smaller appliance, and check if the circuit breaker hasn’t tripped.

If your washing won’t start after troubleshooting the steps above, you’ll need an Electrolux professional to look at the circuitry and identify the faults with the control board.

Electrolux Washer Won’t Fill

If your Electrolux washer isn’t filling with water, the water inlet valve is probably the culprit.

This valve is responsible for the washer’s water supply, and it works if the pressure requirement is met, and it can fail if damaged or if the pressure is too low.

Possible Solution(s):

  • You should be able to see hoses leaving the back of your washer that is attached to cold- and hot-water faucets. Check that these faucets are turned on and that the hoses leading to the unit are not kinked before continuing. Sometimes that is all it takes and doing so may only need turning on these faucets or adjusting the hose.
  • Water inlet valves are the components of a washing machine that tell it when to begin or stop filling. This valve will occasionally fail and fail to signal the machine to fill. This is a relatively simple repair that normally necessitates the services of a technician
  • When the water level reaches a specific level, a sensor alerts them to cease filling. These sensors can fail and alert the washing machine that the water level is too high, even if the unit is empty. The device will not fill until the sensor is repaired or replaced. This will require the services of a technician to resolve

Electrolux Washer Stops Abruptly

If your Electrolux washing machine stops abruptly mid-cycle, the door switch may malfunction, or a faulty water inlet. 

The controller gives the signal to the machine to start once it’s closed, but if it fails, it’ll cause the washing machine to stop mid-cycle.

Another reason can be a faulty water inlet valve that has lost its continuity.

If the Electrolux washer loses power during the cycle, make sure the power supply is properly inserted into the socket and that the circuit is not tripped.

Possible Solution(s):

  • Check the power supply, making sure the washer is properly plugged into the socket. Check that the power cord is not faulty and that the circuit has not been tripped.
  • Replace the door switch, which will require a technician
  • Replace the water inlet valve, which will require a technician

Electrolux Washing Machine Leaking

The most common causes of Electrolux washing machine leaking include an unlevel unit, faulty connections, a damaged pump, or a loose clamp.

Don’t worry; simply follow the steps below to resolve.

Possible Solution(s):

Electrolux Washer Is Not Level

The Electrolux washer could be leaking because your complete unit isn’t level, resulting in an out-of-balance washing drum.

Check that all of your washer’s legs are appropriately spaced on a solid floor.

If your legs aren’t standing equally, review your user handbook to learn how to level them.

Place a level on top of the washer and adjust the legs as needed until your machine’s legs are evenly spaced on the ground.

Water Connection Is Leaking

If you see the leakage from the machine’s bottom, the main hose connection could be to blame.

Check for leaks in the water inlet hose connections to the washer and the water valves in your home.

Tighten any loose connections and replace any damaged valves as needed.

When draped over a sink basin or attached to a sink drain or standpipe, make sure the hose is 60-90 cm high to avoid future seepage.

Defective Water Pump

A faulty water pump or hoses linked to the pump are frequently to blame for leaks under the washer.

If the pump is malfunctioning, you will typically hear a lot of rumbling or shaking coming from the appliance throughout a wash cycle.

A washer’s water pump is often found near the bottom of the appliance.

The two substantial hoses that are attached to the water pump serve as a visual cue.

If any of these connections seem slack or congested, you can visually confirm this.

Hose Clamp Loose or Missing?

Your washing machine’s drain hose should be connected to the drainage pipe that extends from your washer.

A clamp for the hose connection should be visible where they meet.

Your washing machine’s drain hose should be connected to the drainage pipe that extends from the washer.

This clamp may be hidden on the inside of some models, but it is usually visible.

If the connection feels or appears loose, or if there is no clamp or sealed connection at all, water may be leaking out of the bottom of the washer.

In most cases, tightening the water hose by hand is sufficient.

However, there may be times when a replacement part or a professional serviceman is required to complete the task.

How Long Does Electrolux Washing Machine Last?

The lifespan of an Electrolux washing machine is 12 to 14 years.

A washing machine can obviously live more than 14 years if it is used less frequently than this, and it may not last as long if it is used more frequently.

The washer may suffer and may not last as long if you often wash heavy loads as opposed to lighter loads.

Are Electrolux Washing Machines Any Good?

Yes, Electrolux washing machines are excellent. They offer your home the best cleaning and stain removal capabilities available. The Electrolux washer consistently ranks among the top laundry care brands according to professional testing firms. washing machines are excellent.

The top washers from Electrolux now include an intriguing Optic Whites cycle for greater whitening, in addition to SmartBoost, an existing technology that combines water and liquid detergent before adding them to your clothing.

In essence, it’s a supercharged rinse cycle that, according to Electrolux, uses only water to make your clothing whiter than bleach. This second rinse guarantees that every last trace of the soap residue is removed, which prevents leftover detergent from making your whites appear dirty.

Additionally, all Electrolux washers now have Extended Refresh, a wash option that spins and lightly rinses clothing when you can’t remove them straight away to keep them fresh and prevent the development of a musty smell.

What do The Reviews say?

My Kenmore elite front loader was replaced by this Electrolux unit.

Despite having troubles and repairs, the Kenmore lasted 12 years.

This Electrolux has excellent craftsmanship, a quiet operation, and useful options. You’ll kick yourself for not getting an Electrolux 12 years ago!

Source: homedepot.com

 

This washer does an amazing job cleaning clothes. It’s super quiet I had to go check a few times to make sure I turned it on.

The clothes come out so nice and clean that I almost want to rewash everything I own (almost). I have raved and recommended it to everyone!

Source: homedepot.com

 

The washer does an excellent job removing stains. It is extremely gentle on the clothes and gets them clean.

There is a multitude of washing cycles to fit all of your needs. I highly recommend this washing machine.

Source: homedepot.com

 

Pros and Cons Electrolux Washing Machine

Here are some of the pros and cons of Electrolux Washing Machines

Pros

  • Streamlined and look fantastic
  • Robust and easy to use
  • Improved sensor washing for faster cycles
  • Fantastic at removing stains

Cons

  • High price
  • Still no wifi, that helps with service calls, timing, and basic alarms.

Conclusion

So, there you have it: our complete troubleshooting guide for your Electrolux washer so you’re always prepared in the event of a problem.

If you have a fault, carefully read the article and contact a skilled technician.

Cheers!

Related Articles

References

  • https://www.consumeraffairs.com/

Photo Courtesy: Image by gpointstudio on Freepik