When it comes to cleaning up a lawn, the Ryobi leaf blower is the clear answer.
It is not only durable, high-quality, and easy to use but also comes with loads of useful features.
However, the Ryobi leaf blower can run into some common issues.
But there’s nothing to worry about, as you can handle such situations by continuing to read below.
Here are 7 common problems with Ryobi leaf blowers alongside their solutions which you can use to fix the leaf blower.
Ryobi Leaf Blower Won’t Start
Ryobi leaf blower not starting is typically caused by defective spark plug, damaged starter cord, lack of fuel or clogged air filter.
In such a situation, there are several steps you can follow. Continue reading the solutions mentioned below to fix the issue.
Possible Solution(s):
Spark Plug
- The most common reason for this issue is a defective spark plug. Inspect the spark plug for signs of damage and replace the component if it is defective.
Lack of Fuel
- One of the most common reasons for a leaf blower not starting is a lack of fuel. Gas that has been sitting in the tank for 30 days or more can deteriorate, causing the engine to stall or not start properly.
- If the gasoline is left for 6 months or more, it can turn into a thick sludge.
Simply empty the old fuel and replace it with new fuel to correct the situation. To avoid this happening in the future, remove any old fuel before storing your blower for an extended period of time.
Incorrect Fuel Ration
- A proper oil-to-gas ratio is required for a two-stroke engine on a leaf blower. In this case, gas and oil should be mixed 50 parts gas to one part oil. This equates to about 2.6 ounces of oil per gallon of gas and ensures that the engine is adequately fueled.
Otherwise, this could be the cause of a leaf blower not starting. For best results, empty the current oil and fuel and refill with the proper mixture.
Clogged Air Filter
- A clogged air filter is a common issue that could be preventing your leaf blower from starting. Clogged air filters cause the blower’s engine to receive too much fuel and too little air, resulting in a faulty start (or no start at all).
- Combustion engines, in particular, require a continuous flow of fuel and air that enters through the filter and exits through the muffler.
If the air filter is salvageable, it can be scrubbed in soapy water. However, if it is beyond repair, it must be replaced.
Ryobi Leaf Blower Shutting Off
Another common issue relating to starting up is that the Ryobi leaf blower can constantly shut down after starting.
Ryobi leaf blower shutting off is commonly caused by dirty filter, clogged air line, faulty spark plug or lack of fuel.
This can be quite frustrating. However, you can solve the issue by following the solutions below.
Possible Solution(s):
Dirty Filter
- A filter prevents dirt and debris from entering the carburettor throat and causing engine wear.
- A filter can become so clogged that no air can pass through it and the blower will stop working. Inspect the filter, gf the air filter is salvageable, it can be scrubbed in soapy water.
- However, if it is beyond repair, it must be replaced.
Clogged Air Line
- Gummy deposits left by old fuel can restrict fuel flow through the fuel lines. When this occurs, remove the fuel line and replace it with a new one of the same diameter and width.
- If you find dry and cracked fuel lines while inspecting them, you should replace them before they start leaking or drawing air into the line from a puncture.
Faulty Spark Arrestor
- A component known as the spark arrestor is responsible for preventing the emission of sparks from the engine. If this component is clogged, sparks will interfere with the on/off functionality of the leaf blower.
So, clean up the spark arrestor if it is clogged, and try starting the leaf blower.
Faulty Spark Plug
- A faulty spark plug can result in incomplete combustion and a loss of power in your leaf blower. The spark plug may be weak due to incorrect gapping or being fouled with gasoline, in which case it must be replaced.
- To change the spark plug, you’ll need a spark plug wrench or socket wrench. Begin by removing the spark plug boot, then the spark plug with the socket wrench.
The proper gap for your spark plug will vary depending on the model; consult your owner’s manual to determine the proper gap size. Tighten the socket wrench after inserting the new spark plug into the housing.
Lack of Fuel
- Leaf blower cutting out while in operation can be caused by a lack of fuel. Gas that has been sitting in the tank for 30 days or more can deteriorate, causing the engine to stall or not start properly.
- If the gasoline is left for 6 months or more, it can turn into a thick sludge.
Simply empty the old fuel and replace it with new fuel to correct the situation. To avoid this happening in the future, remove any old fuel before storing your blower for an extended period of time.
Ryobi Leaf Blower Not Blowing Hard
Ryobi leaf blower may not blow as hard as it normally does, which is commonly caused by clogged air filter, clogged carburettor or dirty filter.
This can be a major issue, as it can hinder the ability of the appliance to blow away leaves.
However, there’s nothing to worry about, as the below-mentioned solutions can be quite helpful.
Possible Solution(s):
Dirty Filter
- A filter prevents dirt and debris from entering the carburettor throat and causing engine wear.
- A filter can become so clogged that no air can pass through it and the blower will stop working. Inspect the filter, gf the air filter is salvageable, it can be scrubbed in soapy water.
- However, if it is beyond repair, it must be replaced.
Clogged Air Line
- Gummy deposits left by old fuel can restrict fuel flow through the fuel lines. When this occurs, remove the fuel line and replace it with a new one of the same diameter and width.
- If you find dry and cracked fuel lines while inspecting them, you should replace them before they start leaking or drawing air into the line from a puncture.
Dirty Carburettor
- The carburettor is an engine component that mixes gasoline and air. When the two substances combine, they combust, releasing hot gases that power the engine and force air out of the nozzle.
- Assume you neglected to empty it or clean the carburettor. In that case, clumps of debris may have accumulated over time, making air and gasoline flow difficult.
Faulty Spark Plug
- A faulty spark plug can result in incomplete combustion and a loss of power in your leaf blower. The spark plug may be weak due to incorrect gapping or being fouled with gasoline, in which case it must be replaced.
- To change the spark plug, you’ll need a spark plug wrench or socket wrench. Begin by removing the spark plug boot, then the spark plug with the socket wrench.
The proper gap for your spark plug will vary depending on the model; consult your owner’s manual to determine the proper gap size. Tighten the socket wrench after inserting the new spark plug into the housing.
Lack of Fuel
- Leaf blower cutting out while in operation can be caused by a lack of fuel. Gas that has been sitting in the tank for 30 days or more can deteriorate, causing the engine to stall or not start properly.
- If the gasoline is left for 6 months or more, it can turn into a thick sludge.
Simply empty the old fuel and replace it with new fuel to correct the situation. To avoid this happening in the future, remove any old fuel before storing your blower for an extended period of time.
Still not blowing hard, best to take your blower to your local service centre.
Ryobi Leaf Blower Not Charging
Ryobi leaf blowers can also face charging issues from time to time.
Ryobi electric leaf blower battery not charging is commonly caused by dirty terminals or faulty battery
This can eventually cause them to stop working, as there is no power supply. In such a situation, follow the solutions mentioned below.
Possible Solution(s):
- Check the battery terminals for rust and dirt. If they appear to be dirty, simply clean them with an alcohol wipe and a wire brush. Before you start to charge again, ensure the terminals are dry.
- If the terminals are rusty, rub them with sandpaper until they are clear.
- If the batteries still don’t charge, you will need to replace them.
To test a Ryobi battery charger, simply insert a known good battery into the chargers. This method does not require the use of any specialised tools or testing equipment.
Ryobi Leaf Blower Battery, how do I know if defective?
If you have kept your Ryobi leaf blower battery in extremely cold or hot temperatures, then the chances are it is defective.
If you continue to keep the battery in such temperatures, there will be permanent damage caused to the batteries.
However, if you have kept the battery in safe conditions and they do not charge, they may not be defective but instead may be in sleep mode.
Ryobi Leaf Blower Flashing Red Light
A red LED light flashing means there are some battery issues with the leaf blower.
This can allow you to identify and fix the problem.
Here are some solutions which will allow you to effectively use the LED light and fix the battery problem.
Possible Solution(s):
- A flashing red LED light means that the battery is either too hot or too cold. Place the leaf blower in the correct environment and wait for it to reach the right temperature.
- Once the temperature has been reached, the charger will begin charging the battery once again, and the LED light will turn off.
- However, a flashing red LED light can also mean the battery is too low. Once the charger has charged the battery enough, the LED light will turn off.
Ryobi Leaf Blower Flashing Green Light
LED on the Ryobi leaf blower flashing green light indicates battery-related matters.
- The green LED light does not indicate any issues with the battery. All it indicates is that the battery is charging successfully.
- Once the battery has charged, the LED light will stop flashing.
Ryobi Leaf Blower Making Too Much Noise
Leaf blowers make a lot of noise, regardless of the company.
However, as an electric leaf blower, the Ryobi leaf blower should not make the same amount of noise.
If it does, follow the solutions below.
Possible Solution(s):
- First off, clean the air filter or replace it if it appears to be clogged. The air passing through a clogged air filter can produce extra noise.
- Furthermore, clean up the engine and get rid of any debris inside the leaf blower to reduce noise.
How Long Does Ryobi Leaf Blower Last?
A Ryobi leaf blower is built to last up to 10 years, however it does depend on frequency of use and how it is maintained.
What’s best is that you can further add to this incredible lifespan by keeping the leaf blower in good condition through frequent maintenance.
Ryobi Leaf Blowers Any Good?
Yes, Ryobi leaf blowers are very good. Ryobi leaf blowers are great products for every household since they are well built and powerful.
But that’s not all, as the Ryobi leaf blower is also made of durable materials that can last long. Not to mention, Ryobi leaf blowers are easy to use and come with convenient features.
Pros and Cons of Ryobi Leaf Blower
Here are some pros and cons of the Ryobi leaf blower
Pros
- Powerful airflow
- Compatible with other tools for customization
- Easy to use
Cons
- Inconvenient shape
- Poor battery life
- Poor air control
Conclusion
Considering the features, quality, and performance of Ryobi leaf blowers,
it’s safe to say they are a perfect choice if you want to keep your lawn clean.
However, make sure to keep in mind the solutions to the problems above, as you can face them at any time with this product.
Related articles
- Image by teksomolika on Freepik
